If it’s yellow, green, or blue, it’s likely coolant. If you believe the leaking fluid is coolant, check the coolant level. If it’s low, bring your vehicle in for a top-off and inspection. You may be dealing with a blown gasket if your exhaust system is leaking large quantities of water.

The most common reason that someone may end up with water on their Jeep’s floorboard is that a cowl is clogged. The cowl is a drain on the front of your Jeep, and if it is clogged, it is going to cause drainage problems.

A puddle that appears on the floor of your car’s interior — unless you can trace it to a spilled beverage — probably means you’ve got a leak somewhere. It could be a leak that allows rainwater into the cabin, or a leaking component inside the car that’s causing water to leak from behind the dashboard.

Even in stock form, various Jeep Wrangler parts contribute to its natural tendency to leak. For instance, Jeeps have removable front tube doors. Automatically, this allows for water to get in the interior if you are traveling in inclement weather.

1. 5 tips on how to stop your jeep hard top from leaking. Jeep owners are a unique species.
2. Clean around all the rubber seals.
3. Check the Jeep hardtop bolts.
4. Re-adjust and Tighten.
5. Check and Clean Door Seals.
6. Incorporate additional weather stripping.

On a normal Wrangler a hard top cost is $1195.00 Am thinking that the hard top for the Gladiator should cost less since it’s a shorter top, does not go back over the luggage area. And yes it’s got a sliding center back window.

It’s a known issue… take back to dealer for a fix. They’ll likely replace the seals on the freedom tops or on the Jeep itself. Until then get some waterproof seat covers…you may need them down the road anyway.

This three-piece modular hardtop allows easier handling and storage by separating into three manageable pieces. Without the two front panels, the back of the top is now much easier for two adults to remove! This top carries the MOPAR® name trusted by Jeep lovers everywhere.

Passenger side

Locate the positioning pin on the outside edge of the freedom panel, and position the panel such that this pin sits into its corresponding hole in the over-door rollbar. Repeat on driver’s side. After placing each panel, LIFT each panel straight up and gently lower back into place.