If cruise control does not engage after the green light appears, the problem is most likely due to a blown fuse. Open the under-dash fuse box below the instrument panel. Check your owner’s manual to determine which fuse number corresponds to the cruise control feature.

If the cruise control system is intermittently self-disengaging, then this may be a sign that the switch may be having an internal or wiring issue that may be tripping the switch even when the pedal is not depressed.

When the fuse of for the cruise control blows, the cruise control will stop working altogether. A vehicle’s cruise control may stop working if the vacuum actuator has stopped working or if there is damage to the vacuum hoses. The system may also fail if the cable linking the actuator to the throttle is broken.

How much does it cost to fix cruise control on Honda Civic? Expect to pay between $40 and $50 for a replacement, plus the cost of labor. Honda dealership charges $90.

Adaptive Cruise Control (ACC) adjusts the vehicle speed and the following interval to the vehicle detected ahead for enhanced convenience on the highway. When the preceding detected vehicle slows to a stop, ACC can stop the Civic automatically.

Press and hold the Interval button. Cruise mode appears in the Driver Information Interface. Press and hold the Interval button again to switch back to ACC. Press the MAIN button to turn off ACC.

To turn off the cruise main light in the Honda Accord You can either tap the brake pedal, push the cancel button located on the steering wheel, or push the cruise control master button. The cruise main light will turn on when the cruise control button is pushed allowing You to set the system.

To use Cruise Control, turn it on first by pressing the button on the end of the control stalk behind the lower right side of the steering wheel. The green cruise control icon will appear in the instrument display to show the system is ready. Then accelerate to the speed you want, and press the stalk down to set it.

To switch it on, you’ll often press a button marked with the symbol for cruise control: a speedometer symbol with an arrow pointing to a set speed (seen on the stalk below). The most common way to operate cruise control is by using the following buttons: Set Push this to activate the system.

Check engine light Vehicles equipped with ETCS will automatically disable cruise control if there’s a problem with the engine or transmission, so if a check engine light lights up after starting the engine, get the vehicle to a mechanic as soon as possible.

The cruise control fuse is normally found in the fuse panel located below the steering wheel. Remove the cover of the fuse panel and locate the fuse for the cruise control using the fuse diagram on the fuse panel. Using a fuse puller, pull the fuse off the panel.

In most vehicles, the buttons that control the cruise control system appears on the steering wheel. You should check your owner’s manual and locate these buttons when the car is not being driven to avoid an accident. After the cruise control system is activated, set the cruise control.

Operating Cruise Control. Locate your car’s cruise control switches. Usually, these are found either on the steering column (the part connecting the steering wheel to the dashboard area), or on the steering wheel itself. Controls found on the steering wheel usually consist of a few buttons.

Is cruise control bad for your car? Absolutely not. Acceleration that costs fuel also causes wear and tear on the driveline, so cruise control is good for the car.

In the long run, like on long highway journeys, cruise control has the potential to increase your fuel efficiency by 10 to 15 percent. Most people prefer driving at normal speeds, but when the road is wide and the visibility good, you can end up speeding. Simply set a speed limit and let cruise control do all the work.