The Reset button is usually located on the back of your device but can be found on the bottom in some cases.

Program Remote to TV or Other Device

1. Press the HOME button twice, or the MENU button once, depending on your remote.
2. Select Settings.
3. Select Remote Control.
4. Arrow to and select the device code you want to learn.
5. Select the appropriate Pairing Wizard for the device.
6. Follow the on-screen prompts.

If the power cycle does not work, perform a full reset. To run a factory reset, locate the reset button on the connector panel. It’s a small, recessed button that requires a pen to hold down. Hold it for 15 to 30 seconds to reset the television.

My Emerson TV Won’t Turn on

1. Make sure your AC power cord is plugged into the wall outlet.
2. Unplug the cord for one minute.
3. Check the breaker box to make sure the switch that controls the TV isn’t switched to ‘off’.
4. Check the batteries.
5. Make sure there is nothing between your remote and TV.

Typical problems are filter caps in the power supply go bad, and cause it to turn on and off. It will power cycle because there is still energy left in it, and it tricks the controller/logic board to attempt to start up over and over.

A recent “frequency of repair” survey done by a reputable organisation, reported Emerson as ranking 8th out of 20 brands in reliability. Panasonic ranked 1 in quality.

Emerson Radio Corporation is one of the United States’ largest volume consumer electronics distributors and has a recognized trademark in continuous use since 1912….Emerson Radio.

Even for $275, this tv is a bargain.

Emerson 26″, 32″, 37″, 39″, 40″, or 50″ HDTV from $119.99–$349.99 (Manufacturer Refurbished)

The Emerson Radio Corporation is one of America’s largest product designers and licensers. Among other products, it offers flat tube and LCD television sets. The 30-39-inch Emerson televisions can be good additions to a bedroom or small living room.

AC outlet to ensure that AC outlet operates normally. If a power failure occurs, unplug the AC power cord for 1 minute to allow the unit to reset itself. Press only one button at a time. Do NOT press more than one button at the same time.

Look at the screen. If you see a blank screen with a red key on the bottom of the screen, press ‘Function’ and ‘Mute’ at the same time. This should unlock the channel. This is an option for people who want the TV to stay locked but, want to be able to bypass the lock to watch a certain show or channel.