The main function of salt in cake recipes is to enhance the flavor of the other ingredients. You can reduce the salt according to your taste, but if you leave it out completely, you’ll likely find your cakes taste a little “flat.”

If you add too much salt, Curtis recommends using a splash of vinegar. This provides a counterbalancing punch of acid that will lessen the salty taste. And in the event that you add too much spice, all you have to do is drizzle in a bit of honey to mellow out the heat.

Add a Starch Stir in some cooked (unsalted) rice, barley, quinoa, pasta or couscous. These salt-thirsty ingredients will absorb quite a bit from a sauce. Depending on the dish, simmer or bake it with a splash of liquid to meld the flavours and allow the grains to absorb the excess salt.

You taste the sodium ion, and the only chemical way to remove an ion is to make an insoluble salt but all sodium salts are soluble, so no help there. Adding sugar might mask the taste of the sodium (the saltiness) but it is still in there, and many people would still be able to taste it.

To my taste, when adding salt judiciously to enhance the natural flavor of your desserts (again NOT bread)–cakes, puddings, cheesecake, pie filling, hot fudge sauce, and literally every single dessert you can think of–here is my Rule of Thumb: Add 1/4 teaspoon salt per cup of flour.

Most cakes will call for a leavening agent like baking powder or baking soda. These create the bubbles you need for the cake to rise. If the flour you use is self-raising, it already has a leavening agent in it. Make sure your butter is room temperature, and beat the butter and sugar together until properly creamed.

I promise you SOFT & MOIST cakes!

1. Use Cake Flour. Reach for cake flour instead of all-purpose flour.
2. Add Sour Cream.
3. Room Temperature Butter / Don’t Over-Cream.
4. Add a Touch of Baking Powder or Baking Soda.
5. Add Oil.
6. Don’t Over-Mix.
7. Don’t Over-Bake.
8. Brush With Simple Syrup/Other Liquid.

Creaming simply means beating butter with sugar until light and fluffy, trapping tiny air bubbles. The air bubbles you’re adding, plus the CO2 released by raising agents, will expand as they heat up, and the cake will rise. A wooden spoon and elbow grease will do the job, but an electric mixer is your best bet.

Using old or stale baking powder, or baking powder that has been improperly stored, can result in not enough rise, and flat dense cakes. As soon as the water is added to the baking powder the air bubbles are released, so leaving your batter to stand after mixing can also result in flatter, denser cakes.

If you find that your cakes are brown on the outside but are still raw on the inside then it is likely that the oven is too hot. Most cakes are baked at around 180c/350F/Gas Mark 4 on the middle shelf of the oven. Also the cake should be slightly shrinking away from the sides of the cake tin (pan).

Here’s a solution: If you find you underbaked your cake soon after removing it from the oven and it’s still hot, pop it back in and bake it at least another 10 to 15 minutes more. The best way to really prevent under- or over-baking anything is to use an oven thermometer and to check the time it is in the oven.

After you test your cake with a toothpick or paring knife, you’ll want to gauge the texture of the cake another way. The best way to do this is to gently press on the center of the cake with a few fingers to see if it springs back. If your fingers leave little indents, your cake isn’t done baking.

It could be that too much fat has been used to grease the tin; the cake tin wasn’t lined sufficiently; the oven was too hot; the cake was left in the oven for too long or a fat that is not suitable for baking has been used.

Oven Temperature If the oven is too hot, the cake will set too fast before the air bubbles have formed. If the oven is not hot enough, the cake will rise too much, then fall in the center before it is set. To check your oven temperature, bake a cake mix cake for a test run. (Make sure you’ve preheated your oven, too.)

1. Add Extra Frosting. When you’re cake sinks in the middle, grab an extra can of frosting to disguise the low spot. Simply add a bit more frosting or whipped cream and smooth to an even level.

The oven temperature is too high. If the top crust forms and sets before the cake has finished rising, the middle will try to push through the crust as it continues to bake, causing it to crack and possibly dome. Check your oven with an oven thermometer and reduce the temperature accordingly if it is running hot.

To avoid a dome, the best thing to do is lower the temperature by 50F/20C. Baking your cake at 325F or between 160C-170C will ensure that your cake will bake more evenly with no burnt edges. Since you are lowering the temperature, your cake will take longer to bake. Increase the baking time by around half.

When a cake is freshly baked, it needs time to set. Keep the cake in its pan and let it cool on a rack for the time the recipe specifies – usually 15-20 minutes – before attempting to remove it. Try not to let it cool completely before removing it.

Don’t Frost a Warm Cake Baking pros in our test kitchen emphasize that it is essential to let the cake completely cool before frosting. Better yet, you can let the cake sit in the refrigerator for a while to make the process even easier.

No, but the flavor won’t be as good and it will be more difficult to slice. Let it cool to warm before you think about slicing it or eating it. Bread fresh out of the oven needs time for the gluten to set completely.

Our recommendation on how long to cool a cake before icing it, is to wait 2-3 hours for your cake to cool completely. Then add a crumb coat and refrigerate the cake for up to 30 minutes. Once that is done, you’ll be able to ice until your heart’s content.

You don’t want to make the cake soggy, but make sure you cover the whole surface of the cake. Immediately following, cover the cakes tightly with plastic wrap and put aside to cool. If you have a bad recipe or have over-baked your cakes, this will not rescue them from being doomed to dry-ness.

When it comes to Bundt cakes, glaze (or even caramel sauce) is a much better choice then frosting. It adds that extra sweetness you’re looking for, but it’s thin enough to show off those pretty ridges.

Take about 1/2 cup of frosting and thin it out with a little milk or water so it’s very easy to spread. With an offset spatula, spread a thin layer of it on the tops and sides of the cake, then chill until set, about 15 minutes. Repeat if you can still see crumbs showing through the icing.

Icing On The Cake Game – Play online for free | KibaGames.